Read MD 3060-3066-3560 Operating Tips text version

Die Cut Line (.5 inch radius)

MD 3060-3066-3560 OPERATING TIPS (WTEC III CONTROLS)

SELECTOR POSITION R N

(1-6) (1-5) (1-4) (1-3) (1-2)

RANGE COVERAGE

REVERSE NEUTRAL 1ST CONVERTER THRU 6TH LOCKUP 1ST CONVERTER THRU LOCKUP IN SELECTED RANGE

OPERATING CONDITIONS

BACKING VEHICLE STARTING ENGINE AND STATIONARY OPERATION PAVED ROADS -- NORMAL DRIVING PAVED ROADS, RANGE DETERMINED BY ROAD, SPEED CONTROL, LOAD AND TRAFFIC CONDITIONS. THE LOWER THE RANGE, THE GREATER THE BRAKING. SPEED CONTROL, OFF-HIGHWAY CONDITIONS, PULLING THROUGH MUD, DEEP SNOW, UP AND DOWN STEEP HILLS. MAXIMUM OUTPUT POWER AND MAXIMUM BRAKING.

D

1

1ST CONVERTER

CAUTIONS

N TO D, N TO R MODE BUTTON: SELECTIONS MAY BE INHIBITED BASED ON CONDITIONS WHEN REQUEST IS MADE. WHEN THIS OCCURS, RE-SELECT NEUTRAL AND THEN THE REQUESTED RANGE WITH ENGINE AT IDLE AND SERVICE BRAKES APPLIED. THE "MODE ON" LIGHT WILL INDICATE YOU HAVE SELECTED THE SECONDARY MODE FOR AN ALTERNATE SHIFT CALIBRATION AND/OR SPECIAL FUNCTION. BOTH PRIMARY AND SECONDARY CALIBRATIONS MAY OR MAY NOT UTILIZE ALL SIX RANGES. PLACE SELECTOR IN NEUTRAL. NOTE: ENGINE CANNOT BE STARTED BY PUSHING OR TOWING VEHICLE. BEFORE TOWING A DISABLED VEHICLE, DISCONNECT DRIVELINE OR PULL AXLE SHAFTS OR TOW WITH DRIVE WHEELS SUSPENDED. SELECT POSITION GIVING MAXIMUM ENGINE SPEED FOR DESIRED VEHICLE SPEED DESCENDING GRADE. IF ENGINE RPM IS ALLOWED TO EXCEED GOVERNED SPEED, THE TRANSMISSION MAY UPSHIFT ABOVE THE HIGHEST SELECTED RANGE. DOWNSHIFTS TO LOWER RANGES WILL NOT OCCUR UNTIL SPEED IS REDUCED. CONTINUE TO DRIVE TO SAFE LOCATION FOR SERVICE ASSISTANCE. SELECTOR DISPLAY WILL FLASH AND SHOW ACTUAL RANGE ATTAINED. SHIFTS WILL BE RESTRICTED AND LOCKUP WILL DISENGAGE. THE SHIFT SELECTOR WILL NOT RESPOND TO YOUR COMMANDS. RESTARTING THE ENGINE MAY CLEAR THE LIGHT ALLOWING NORMAL CONTINUED SERVICE. THE TRANSMISSION MAY, HOWEVER, HOLD IN NEUTRAL, REQUIRING IMMEDIATE ATTENTION IF THE PROBLEM DOES NOT CLEAR.

STARTING: TOWING: DOWNHILL BRAKING:

CHECK TRANS

TRANSMISSION SERVICE HINTS

­ CHECK FLUID AT OPERATING TEMPERATURE, NEUTRAL, BRAKES ON, IDLING, ON LEVEL SURFACE. ­ ADD RECOMMENDED FLUID ­ TranSyndTM OR DEXRON®-III (ETC REQUIRES USE OF TranSyndTM OR TES 295 EQUIVALENT). ST3042EN 200010

Information

MD 3060-3066-3560 Operating Tips

1 pages

Find more like this

Report File (DMCA)

Our content is added by our users. We aim to remove reported files within 1 working day. Please use this link to notify us:

Report this file as copyright or inappropriate

57576


You might also be interested in

BETA
http://www.baumtools.com/bmwcod
s60techguide_040704.pdf