Read Microsoft Word - sharpiemetallic_39100.doc text version

MATERIAL SAFETY DATA SHEET

Section One: Identification

MSDS #

39100

Sanford, L.P. 2707 Butterfield Road Oak Brook, IL 60523 USA 800-323-0749 or 630-481-2000 Product Name: Colors: Sharpie Metallic Permanent Marker Silver, Gold, Bronze

EMERGENCY MEDICAL NUMBER: 888-786-0972

NewellRubbermaid, Inc (Sanford L.P.) is a member of The Art and Creative Materials Institute, Inc. This product is certified by the Institute to be labeled in accordance with the voluntary chronic hazard labeling standard ASTM D-4236 and is labeled with the AP Non Toxic Seal. Products bearing the AP Approved Product Seal of The Art and Creative Materials Institute, Inc. are certified in a program of toxicological evaluation by a medical expert, subject to review by the Institute Toxicology Advisory Board, to contain no materials in sufficient quantities to be toxic or injurious to humans, or to cause acute toxicity or chronic health problems.

Section Two:

Hazard Identification

This product is considered safe under normal use conditions.

Section Three:

Composition

Solvent naphtha (64742-89-8), metallic pigments, resins, additives Silver ONLY: nitroparaffin solvent (79-24-3,108-03-2), butanol (71-36-3)

Section Four:

Inhalation: Skin Contact: Eye Contact: Ingestion:

First Aid Measures

This product is considered safe under normal use conditions. This product is considered safe under normal use conditions. This product is considered safe under normal use conditions. This product is considered safe under normal use conditions.

Section Five:

Flash Point:

Fire Fighting Measures

50F (TCC) for solvent naphtha Lower: Not determined Upper: Not determined

Flammability Limits (% by volume): Extinguishing Media: Special Fire Fighting Measures: Unusual Fire and Explosion Hazards:

Dry chemical, foam, carbon dioxide In fires involving large quantities, use a self-contained breathing apparatus. Cool fire-exposed containers with water fog/spray. None

Section Six:

Accidental Release Measures

Wipe up with absorbent material.

In Case of Spill or Accidental Release:

Section Seven:

Handling: Storage:

Handling and Storage

Do not shake marker. Keep cap on marker when not in use. Store markers point down.

Section Eight:

Eye Protection: Clothing: Respirator: Ventilation: January 27, 2012

Exposure Controls and Personal Protection

None under normal use conditions. None under normal use conditions. None under normal use conditions. None under normal use conditions. Page 1 of 2

MATERIAL SAFETY DATA SHEET

MSDS #

39100

Section Nine:

Boiling Point: Specific Gravity: Vapor Pressure: Solubility in Water: Evaporation Rate: Appearance/Odor:

Physical and Chemical Properties

For ink unless otherwise specified: Greater than 100F Not determined Not determined Miscible Not determined Metallic liquid; slight odor

Section Ten:

Stability: Conditions to Avoid: Chemical Incompatibility: Hazardous Decomposition: Hazardous Polymerization:

Stability and Reactivity

Stable Not available Not available Not available Will not occur.

Section Eleven:

Toxicological Information

See Section Two: Hazard Identification for any hazards

Section Twelve:

Not available

Ecological Information

Section Thirteen:

Disposal Considerations

Dispose in accordance with Federal, State, and Local Regulations.

Section Fourteen:

DOT: IATA: IMO:

Transport Information

Not regulated Not regulated Not regulated

Section Fifteen:

TSCA:

Regulatory Information

The product listed on this Material Safety Data Sheet is not listed on the Toxic Substances Control Act Inventory. All ingredients used to manufacture this product are listed on the TSCA Inventory

Section Sixteen:

HMIS Code Health Flammability Reactivity Personal Protection

Other Information

N/A N/A N/A N/A

0=Minimal / 4 = Severe January 27, 2012

NewellRubbermaid, Inc (Sanford L.P ) has been advised by Counsel that the OSHA Hazard Communication Standard and the Health Canada Workplace Hazardous Materials Information Standard do not apply to the product described in this Material Safety Data Sheet. The reasons for the exemptions are contained in 29 CFR 1910.1200(b)(6)(ix) as amended Sept 14, 2009 per the Code of Federal Regulations and also Canadian Hazardous Products Act part 12 section (f) as amended June 1, 2009. The information contained in this MSDS is forwarded to you for your information, but is not meant to imply that the product is covered by nor is this MSDS meant to comply with all requirements of the hazard communication standards.

Page 2 of 2

Information

Microsoft Word - sharpiemetallic_39100.doc

2 pages

Report File (DMCA)

Our content is added by our users. We aim to remove reported files within 1 working day. Please use this link to notify us:

Report this file as copyright or inappropriate

531754


You might also be interested in

BETA
Microsoft Word - R7177657.rtf
file://P:\ProductVision%204.0\Reports\~PV71448.htm
\\server01\hse\archives\ansiosh