Read 6-09.qxp text version

2000-2001 Honda CBR929 2002-2003 Honda CBR954

I n s ta l l a t i o n I n s t r u c t i o n s Parts List 1 1 1 1 Ignition module Velcro

®

Installation Guide Alcohol Swab Strip

You can also download the

Power Commander software and latest maps from our web site at: www.powercommander.com

The ignition MUST be turned OFF before installation! This module is intended to be used in conjunction with Power Commander 104-41 or 1 1 10-41 1

Power Commander may need to be updated.

(see included instructions)

Before this module can be used the

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993

6-09

www.powercommander.com

2000-2003 Honda CBR929/954 - Ignition module - 1

1 2 3 4

Remove the seats. Lift the front of the fuel tank up. Remove the air box lid. Remove the 6 screws for the velocity stacks that hold the air box to the throttle bodies (Fig. A).

Fig. A

5

Move the air box out of the way to gain access to the coil sticks.

Remove these screws

6

Place the ignition module next to the left hand side of the bike going towards the engine.

PCIII and route the harness down the

Fig. B

7

Unplug from coil sticks

Disconnect the stock wiring harness from the coil sticks (Fig. B).

8

Connect the ignition module connecand coil sticks (Fig. C). Ignition module colors: ORANGE - Cylinder #1 YELLOW - Cylinder #2 GREEN - Cylinder #3 BLUE - Cylinder #4

tors in-line of the stock wiring harness

6-09

Fig. C

www.powercommander.com

2000-2003 Honda CBR929/954 - Ignition module - 2

9

Locate the crank pickup coil connector (Fig. D). 2 pin connector located on the right hand side of the bike behind the throttle bodies.

Fig. D

This connector is a RED

Unplug crank

connector

Stock connectors

Fig. E

10

Plug

module in-line of the stock crank

the connectors from the ignition

pickup sensor connectors (Fig. E).

Module connectors

Ground wire

Fig F

Ignition module harness

11

Attach the ground wire from the ignibattery (Fig. F).

tion module to the negative side of the

6-09

www.powercommander.com

2000-2003 Honda CBR929/954 - Ignition module - 3

10

Install the ignition module in the tail section of the bike.

to the top of the PCIII if necessary by using the supplied velcro. 11

It can be attached

Plug the white 10 pin connector from port of the PCIII. If you are using a

Fig. G

the ignition module into the expansion quickshifter then unplug the quickthe expansion port of the igntion module harness.

shifter from the PCIII and connect to

12

Reinstall the airbox and bolt down the fuel tank. box. connectors are reattached to the air-

Make sure all the hoses and

6-09

www.powercommander.com

2000-2003 Honda CBR929/954 - Ignition module - 4

Information

6-09.qxp

4 pages

Report File (DMCA)

Our content is added by our users. We aim to remove reported files within 1 working day. Please use this link to notify us:

Report this file as copyright or inappropriate

408345


You might also be interested in

BETA
6-09.qxp