Read I717-411.qxd text version

2003-2004 Ducati Monster 1000sie

Installation Instructions Parts List Button Adjustment Display Power Commander USB Cable CD-ROM Installation Guide Power Adapter Wire Tap Power Commander Decals Dynojet Decals Velcro® Strip Faceplate Buttons Alcohol Swab

Expansion Port USB Port

1 1 1 1 1 1 2 2 1 1

The ignition MUST be turned OFF before installation!

You can also download the Power Commander software and latest maps from our web site at: www.powercommander.com

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 (800) 992-4993 www.powercommander.com

i717-411 2003-2004 Ducati Monster 1000S - PCIII USB - 1

1. 2. 3.

Fig. A

Remove the seat Lift the front of the fuel tank up. Install the Power Commander on top of the battery as shown in Fig. A. Use the stock rubber battery strap to hold the Power Commander in place. Route the wiring harness from the Power Commander towards the left hand side of the bike. Go between the engine and the frame and route towards the throttle bodies. Locate the stock connector for the rear injector (Fig. B). Unplug the connector from the injector.

4.

Unplug this connector

5. 6.

Fig. B

7.

PCIII connectors

Plug the ORANGE colored wires from the Power Commander in-line of the stock connector and front injector (Fig. C). Route the YELLOW colored wires to the right hand side of the bike. Route wires under air box and between the throttle bodies. Repeat steps 6 & 7 for the front injector.

8.

Fig. C

Stock connector

9.

i717-411

www.powercommander.com

2003-2004 Ducati Monster 1000S - PCIII USB - 2

10.

Stock TPS connector

Locate the Throttle Position Sensor (TPS). This sensor is located on the L.H side of the bike, between the frame and the throttle body. Unplug the sensor and pull the connector towards the outside of the frame to access the wires (Fig. D). Locate the ORANGE wire of the TPS connector (position C). Attach the supplied wire tap to the ORANGE wire (Fig. E). Use firm pressure to make sure the wire tap is closed.

Fig. D

11.

12. 13.

Wire tap

Note: It is recommended to use dielectric grease on this connection. Fig. E

14.

Plug the grey wire from the Power Commander to the supplied wire tap (Fig. F).

Note: It is recommended to use dielectric grease on this connection.

Stock TPS connector

15. 16.

Plug the connector back onto the TPS. Attach ground wire from the Power Commander to the negative side of the battery. Make sure the wiring harness of the Power Commander is not in a location that it will get pinched or melted. Lower the fuel tank back into position. Reinstall the seat.

Gray wire from PCIII

17.

Fig F

Stock TPS connector

19. 20.

i717-411

www.powercommander.com

2003-2004 Ducati Monster 1000S - PCIII USB - 3

Information

I717-411.qxd

3 pages

Report File (DMCA)

Our content is added by our users. We aim to remove reported files within 1 working day. Please use this link to notify us:

Report this file as copyright or inappropriate

491601


You might also be interested in

BETA
I308-211.PDF
I717-411.qxd
6-52.qxp
I110-211.PDF
I110-411.qxd