Read Microsoft Word - Breaking_in_instructions.doc text version

ENGINE BREAKING IN INSTRUCTIONS

AXE Rossi high performance engines must be correctly broken-in for maximum performance and life! Rushing this process can result in premature engine failure. The carburetor of our AXE Engines is set at the factory at a rich setting for an easy start of the engine. The factory initial setting is the following: Main needle 3.5 turn open from closed position ­ Idle needle 2.5 turn open from closed position. For a good break-in run the engine while the car is sitting off the ground at that rich setting for 3, 4 tanks and then for the next 3-6 liters (1-1,5 gallons) run it on the ground at a low speed and gradually speed it up while you progress through each tank and leaning the high speed needle 1/8th of a turn at a time until it runs close to peak performance. Please don't take short cuts and run less tanks. Make sure the engine stays within a reasonable temperature range 110-120°C (230248°F) and make sure you see a good amount of blue smoke coming out of the exhaust throughout the throttle range to insure you are not running the engine overly lean. Do not run the engine too lean or you will over heat it and cause permanent damage to the internal components of the engine. Remember always run the engine with a clean air filter. FUEL The fuel is very important for the run of the engine. The correct fuel need to contain: NITRO 20-30% Syntetic Oil 6-8% Castor Oil 2-3% Axe recomomand the following Fuel brands: AXE by ROGA ROGA BYRON O'DONNELL MECCAMO AXE MOTOR ROSSI ­ Via Caporalino, 5 ­ 25060 Cellatica BS Italy ­ axemotor.it

Information

Microsoft Word - Breaking_in_instructions.doc

1 pages

Find more like this

Report File (DMCA)

Our content is added by our users. We aim to remove reported files within 1 working day. Please use this link to notify us:

Report this file as copyright or inappropriate

499710


You might also be interested in

BETA
Apr16 p26-27 Classics copy.indd